User's Manual

the paper to the desired position. See the section on
adjusting the top of form position in Chapter 2.
To reset the tear-off position, take the printer off line and
press the TEAR OFF button to enter the tear-off mode and
feed the paper to the tear-off position. Then use the
MICRO FEED buttons to move the paper to the desired
position. See the section on using automatic tear-off in
Chapter 2.
To adjust the printing position, take the printer off line
and press either MICRO FEED button to advance or
reverse the paper to the desired position. See the section
on adjusting the printing position in Chapter 2.
WARNING: When using labels, only feed the paper
forward with the top MICRO FEED button. Labels must
never be fed backward through the printer.
The TOP OF FORM button lets you enter and exit the top
of form mode when the printer is off line so you can
adjust the top of form position. The top of form position
determines where the printing begins on each page.
If your printing is too high or low on the page, you can
reset the top of form position by entering the top of form
mode and using micro-feed to adjust the position. The
printer remembers this new top of form position even
after it is turned off, reset, or initialized. Also, the printer
remembers separate top of form positions for the front
and rear tractors.
If you enter the top of form mode by mistake, you can
exit the mode without setting a new position by pressing
the ON LINE button. See the section on adjusting the top
of form position in Chapter 2.
3-6 Using the Printer