Printer User Manual
Table Of Contents
- ADDENDUM
- FRONT MATTER
- TABLE OF CONTENTS
- ABOUT THIS MANUAL
- INTRODUCTION
- CHAP 1-SETTING UP THE PRINTER
- CHAP 2-PAPER HANDLING
- CHAP 3-USING THE PRINTER
- CHAP 4-SOFTWARE AND GRAPHICS
- CHAP 5-USING THE PRINTER OPTIONS
- CHAP 6-MAINTENANCE
- CHAP 7-TROUBLESHOOTING
- CHAP 8-TECHNICAL SPECIFICATIONS
- CHAP 9-COMMAND SUMMARY
- APPENDIX
- INDEX
- QUICK REFERENCE
Paper Cutter
6..
Open the rear flap and remove it by lifting up to pull the pegs
on the rear flap out of the notches at the back of the printer.
Then plug the paper cutter’s connector securely into the
connector inside the printer.
7..
To replace the rear flap, fit the pegs on the rear flap into the
notches
at the back of the printer. Then dose the rear flap.
5-22
Using the Printer Options