User`s guide

Connecting to a Projector on a Network and Projecting
16
3 Status
The following six icons indicate the status of the detected projectors.
Standby Select for connecting.
Busy Select for connecting. When you click
Connect, the computer currently
connected is disconnected and your
computer is connected.
Busy (Disable
interrupt
connection)
Cannot be selected. Disable
interrupt connection is set on
another computer which is already
connected.
Currently in
use by
another
application
The projector's Configuration Menu is
open. You can select it after closing
the Configuration menu and running
the search again.
Searching Displayed while running Manual
search or Profile.
Not found. Displayed when a projector cannot be
found as a result of Manual search or
Profile. In Quick Connection Mode,
you can only select multiple
projectors with the same SSID.
4 Projector name
The projector's name is displayed.
5 Disable interrupt connection
Check the box to prevent an interrupt connection by other computers
while connected to the selected projector.
6 Use multi-display
Check the box to use the Multi-screen display function. When this is
selected, Display layout and Display properties are displayed at the
bottom of the screen.s p.24
7 Troubleshooting
If there is a problem and you cannot make a connection, press this
button to open the EasyMP Network Projection Troubleshooting
screen.
8 Connect
Connect to the projector you selected from the search results list.
When a connection is made with a projector, a toolbar is displayed.
9 Set options
You can set general setting options such as the processing method
when starting EasyMP Network Projection. For details, see Set options
s p.38
10 Save in the profile
Saves the results of a network projector search as a Profile.s p.33
11 Clear list
Deletes all search results.
12 IP address (Advanced Connection Mode only)
The projector's IP address is displayed.
13 Display
(Select the number displayed (when Use multi-display is selected).
s p.30
14 Profile
You can search for a projector on the network using a Profile
saved using Save in the profile. s p.33
15 SSID (Quick Connection Mode only)
The projector's SSID is displayed.
16 Signal intensity
This is displayed when the connection is made in Quick Connection
Mode. As the Signal intensity increases, so does the number of lit
indicators.