User`s guide

Preparing Your Projector
Follow the steps below to put the projector into connection standby status.
When connecting via wired LAN, check that the projector is connected to
the network with a commercially available network cable. When connecting
via wireless LAN, install the wireless LAN unit in the projector.
a
Turn on your projector.
b
Make the projector's network settings.
When connecting the computer to the projector via wireless LAN,
connect using the Advanced connection mode. You cannot connect
using the Quick connection mode.
See the following manual for more details on network settings.
s User's Guide
c
Change the projector's input source to LAN.
The LAN standby screen is displayed.
Preparing Your Computer
Follow the steps below to connect the computer to the projectors and start
projecting.
a
Install EasyMP Multi PC Projection on the computer.
s "Installing the Software" p.6
b
Make the computer's network settings, and connect the computer
to the network.
s Computer's documentation
a
When the computer you are using is already connected to the
network, you do not need to make network settings on the
computer.
c
Start EasyMP Multi PC Projection.
s "Starting EasyMP Multi PC Projection" p.15
Preparing to Connect
14