Operation Manual

2. Allocating the image to be projected s p.26

Open the file to be projected, and then move the screen to the virtual display

according to the actual projection arrangement.

3. Projecting the allocated images s p.26

Allocate a virtual display number to a projector that is connected through the

network, and then start projection.

Setting the Virtual Display

This section explains the virtual display for arrangement example 1. s

p.21

Enable the virtual display driver (Windows only)

Enable the virtual display

driver. Those users listed below do not have

to perform this operation. Go to procedure

s "Adjusting the Virtual

Display" p.22.

• Those users who have enabled virtual displays installing EasyMP

Network Projection.

• For Macintosh users.

Procedure

Start Windows on the computer, then select "Start" -

"Programs" (or "All Programs") - "EPSON Projector" -

"Add-Remove EPSON Virtual Display".

The Add-Remove EPSON Virtual Display screen is displayed.

Select the virtual display you want to use.

Up to four monitors can be added. In this example, a single

virtual display is to be used. When setting multiple virtual

displays, select as many displays as is necessary.

Any one of the displays can be selected.

Click "OK".

When you click OK, the drivers for the virtual display are

enabled. At this point, it is normal for the display to flicker. Wait

for the Add-Remove EPSON Virtual Display screen to close.

Adjusting the Virtual Display

After starting EasyMP Network Projection, the setup of the virtual

displays varies between Windows and Macintosh. The procedures are

explained separately below.

Procedure

For Windows

Select "Start" - "Programs" (or "All Programs") - "EPSON

Projector" - "EasyMP Network Projection" to start EasyMP

Network Projection.

Select the "Use multi-display" check box.

Using Multi-Screen Display