Operation Manual

Slideshow lets you play back and project image files stored on USB

storage devices and digital cameras.

This section explains the basic operations for Slideshow.

Although the following steps are explained based on the Remote

Control, you can perform the same operations from the projector’s

Control panel.

Starting and Closing Slideshow

Starting Slideshow

Procedure

Switch the projected image to USB.

s User's Guide "Changing the Projected Image"

Connect the USB storage device or digital camera to the

projector.

s User's Guide "Connecting and Removing USB Devices

(EB-1925W/1920W/1915/1910/1830 only)"

Slideshow starts and the file list screen is displayed.

Closing Slideshow

Procedure

To close Slideshow, disconnect the USB device from the

USB(TypeA) port on the projector. For digital cameras, hard disks,

and so on, turn off the power to the device and then disconnect.

• You can also connect a memory card to the projector by loading

it in a USB card reader. However, some card readers may not

be compatible.

• When the following screen (Select drive screen) is displayed,

press the [

][ ][ ][ ] buttons to select the drive you

want to use, and then press the [Enter] button.

• To display the Select drive screen, position the cursor on Select

drive in the top half of the file list screen, and then press the

[Enter] button.

Slideshow Basic Operations

The following describes the procedures for playing images using

Slideshow, and projection operations.

Procedure

Use the [ ][ ][ ][ ] buttons to position the

cursor on the file or folder you want to access.

Slideshow Basic Operations