Operation Manual

Name Function

[ID] button

Hold down this button and press the numeric buttons to

select the ID for the projector you want to operate using

the remote control.

s "Setting an ID and using the remote control" p.65

[Color Mode] button

Each time the button is pressed, the Color Mode changes.

s "Selecting the Projection Quality (Selecting Color

Mode)" p.43

[LAN] button

Switches to the image from the network connected device.

[USB] button

Each time the button is pressed, the image displayed

changes between the following sources.

• USB Display

• Images from the device connected to the USB(TypeA)

port

[Source Search]

button

Changes to the next input source that is sending an image.

s "Automatically Detect Input Signals and Change the

Projected Image (Source Search)" p.31

Remote control light-

emitting area

Outputs remote control signals.

Replacing the remote control batteries

If delays in the responsiveness of the remote control occur or if it does not

operate after it has been used for some time, it probably means that the

batteries are becoming flat. When this happens, replace them with new

batteries. Have two AA size manganese or alkaline batteries ready. You

cannot use other batteries except for the AA size manganese or alkaline.

Attention

Make sure you read the following manual before handling the batteries.

s Safety Instructions

Remove the battery cover.

While pushing the battery compartment cover catch, lift the cover

up.

Replace the old batteries with new batteries.

Part Names and Functions