Operation Manual

Submenu Function
Display
You can make settings related to the projector's display.
Messages: When set to Off, the following items will not be
displayed.
Item names when the Source, Color Mode, or Aspect Ratio
is changed, messages when no signal is being input, and
warnings such as High Temp Warning.
Display Background
*1
: You can set the screen background
to Black, Blue, or Logo when no image signal is available.
Startup Screen
*1
: Set to On to display the User's Logo
when projection starts.
A/V Mute
*1
: You can set the screen displayed when the
remote control's [A/V Mute] button is pressed to Black,
Blue, or Logo.
User's Logo
*1
You can change the user's logo that is displayed as a
background during Display Background, A/V Mute, and so
on.
s "Saving a User's Logo" p.68
Projection
Select from one of the following projection methods
depending on how the projector is installed.
Front, Front/Ceiling, Rear, and Rear/Ceiling
You can change the setting as follows by pressing down
the [A/V Mute] button on the remote control for about five
seconds.
Front
W
Front/Ceiling
Rear
W
Rear/Ceiling
s "Installation Methods" p.20
Submenu Function
Operation
Direct Power On: Set to On to turn on the projector
simply by plugging it in.
When the power cord is plugged in, note that the projector
turns on automatically in cases such as a power outage
being restored.
Sleep Mode: When set to On, this automatically stops
projection when no image signal is being input and no
operations are carried out.
Sleep Mode Timer: When Sleep Mode is set to On, you
can set the time before the projector automatically turns off
within a range of 1 to 30 minutes.
Lens Cover Timer: When set to On, this turns off the
power automatically 30 minutes after the A/V mute slide is
closed.
The default value is On.
High Altitude Mode: Set to On when using the projector
above an altitude of 1500 m.
Audio Input: When set to Auto, the audio from the input
source is output.
When set to Audio1, Audio2, or Audio (L/R), audio is
output from the selected port regardless of the input source
as long as audio is input from the audio input port.
Standby Mode
If you set Communication On, you can perform the
following operations even if the projector is in standby
mode.
Monitoring and controlling the projector over a network
s "Monitoring and Controlling" p.74
Outputting analog RGB signals from the Computer1 port
to an external monitor
Projector ID
Set the ID to a number between 1 and 9. Off indicates that
no ID is set.
s "Setting the projector ID" p.66
List of Functions
92