User`s guide

Attention
The Easy Interactive Function operates by infrared communication. Note the
following important points when using this function.
• Make sure there is no strong light or sunlight shining on the Easy Interactive
Function receiver or the projection screen.
• If there is any dust stuck to the Easy Interactive Function receiver, it could
interfere with infrared communication and you may not be able to use the
function normally.
• Do not put paint or any stickers on the cover of the Easy Interactive
Function receiver.
• Install the projector so that the Easy Interactive Function receiver is not too
close to fluorescent lights.
• Do not use an infrared remote control or infrared microphone in the same
room because the Easy Interactive Pen may malfunction.
• The Easy Interactive Function may be interrupted by electromagnetic
interference from nearby equipment (such as electric motors or transformers).
• The Easy Interactive Pen is not waterproof. Do not use it with wet hands, or
in locations where it may get wet.
• Do not hold the black section of the pen tip of the Easy Interactive Pen, and
make sure this section does not get damaged or soiled. Otherwise, the Easy
Interactive Pen may not work.
• When operating Keystone, performance for the Easy Interactive Function may
decline.
Drawing with the Projector's Built-in Function
Procedure
a
Turn on the projector.
b
Perform the pen calibration.
You can skip this step if pen calibration is already complete.
s "Calibrating the pen" p.59
c
Put the Easy Interactive Pen close to the projected screen near the
toolbar tabs [
] on the left and right of the screen.
d
Click one of the toolbar tabs [ ].
The toolbar is displayed.
When the toolbar is displayed, you can write on the projected screen using
the Easy Interactive Pen.
Easy Interactive Function (EB-485Wi/EB-480i/EB-475Wi only)
58