Operation Manual

f
Repeat procedures 4 and 5 as needed to adjust any remaining
corners.
g
Press the [Esc] button to exit the correction menu.
Because Keystone was changed to Quick Corner, the corner
selection screen shown in step 4 is displayed the next time you press
the [
w] or [v] button on the control panel. Change Keystone to
H/V-Keystone if you want to perform horizontal and vertical
correction using the [
w] or [v] button on the control panel.
s Settings - Keystone - H/V-Keystone p.119
a
If the [Esc] button is held down for about two seconds while
the corner selection screen from step 4 is displayed, the
following screen is displayed.
Reset Quick Corner: Resets the result of Quick Corner
corrections.
Switch to H/V-Keystone: Switches the correction method to
H/V-Keystone.
s "Settings Menu" p.119
H-Keystone Adjuster (EB-536Wi only)
Move the horizontal keystone adjuster to the right or left to perform
horizontal keystone correction.
a
• When using H-Keystone Adjuster, set H-Keystone Adjuster to
On.
s Settings - Keystone - H/V-Keystone - H-Keystone Adjuster
p.119
• You can also correct keystone distortion in the horizontal direction
using H/V-Keystone.
Adjusting Projected Images
51