Operation Manual

A
Extend the rear foot.
B
Retract the rear foot.
Correcting the Focus
You can correct the focus using the focus ring.
Adjusting the Volume
You can adjust the volume using one of the following methods.
• Press the [Volume] buttons on the remote control to adjust the volume.
[
a] Decreases the volume.
[
b
] Increases the volume.
Remote control
• Adjust the volume from the Configuration menu.
s Settings - Volume p.119
Caution
Do not start when the volume is set too high.
A sudden increase in volume may cause loss of hearing. Always lower the
volume before powering off, so that you can power on and then gradually
increase the volume.
Selecting the Projection Quality (Selecting Color
Mode)
You can easily obtain the optimum image quality simply by selecting the
setting that best corresponds to your surroundings when projecting. The
brightness of the image varies depending on the mode selected.
Mode Application
Dynamic
Ideal for use in a bright room. This is the brightest mode.
Adjusting Projected Images
53