User`s guide

Switching to the Target Image by Remote Control
You can change directly to the target image by pressing the following
buttons on the remote control.
Remote control
A
Each time the button is pressed, it cycles through the following images:
• Computer1 port
• Computer2 port
B
Each time the button is pressed, it cycles through the following images:
• S-Video port
• Video port
• HDMI port
C
Each time the button is pressed, it cycles through the following images:
• USB Display
• Images from the device connected to the USB(TypeA) port
D
Changes to the image projected with EasyMP Network Projection. When
projecting using the optional Quick Wireless Connection USB Key, this
button switches to that image. (EB-93 only)
Projecting with USB Display
You can use the commercially available USB cable to connect the projector
to a computer to project images from the computer.
To start USB Display, set USB Type B to USB Display from the
Configuration menu.
s Extended - USB Type B p.78
System requirements
For Windows
OS
Windows 2000 Service Pack 4
The following 32 bit operating systems:
Windows XP
Windows XP Service Pack 2 or later
Windows Vista
Windows Vista Service Pack 1 or later
Windows 7
The following 64 bit operating systems:
Windows 7
CPU
Mobile Pentium III 1.2 GHz or faster
Recommended: Pentium M 1.6 GHz or faster
Amount of
Memory
256 MB or more
Recommended: 512 MB or more
Hard Disk
Space
20 MB or more
Display
Resolution of no less than 640x480 and no higher than
1600x1200.
Display color in 16-bit color or greater
Projecting Images
30