Operation Manual
Submenu Function
Port Number
You can input the port number for the SMTP server. The default
value is 25. You can input numbers between 1 to 65535.
From
Enter the email address of the sender.
Address 1 Set-
ting/Address 2
Setting/Address
3 Setting
Set the destination email addresses for the notification email, and
the notification content. You can register up to three
destinations. You can enter up to 32 single-byte alphanumeric
characters for the email addresses. ( " ( ) , : ; < > [ \ ] and spaces
cannot be used.)
SNMP
Set to On to monitor the projector using
SNMP
g
. To monitor
the projector, you need to install the SNMP manager program on
your computer. SNMP should be managed by a network
administrator. The default value is Off.
Trap IP Address
1/Trap IP Ad-
dress 2
You can register up to two IP addresses for the SNMP trap
notification destination.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from
0 to 255)
Community
Name
Set the community name of SNMP. You can enter up to 32 single-
byte alphanumeric characters. (Spaces and symbols other than @
cannot be used.)
Others menu
Submenu Function
Priority Gateway
For the priority gateway, select either Wired or Wireless.
AMX Device Dis-
covery
When you want to allow the projector to be detected by
AMX
Device Discovery
g
, set this to On. Set this to Off if you are not
connected to an environment controlled by a controller from
AMX or AMX Device Discovery.
Crestron Room-
View
Set this to On only when monitoring or controlling the projector
over the network using Crestron RoomView
®
. Otherwise, set
this to Off.
s "About Crestron RoomView
®
" p.212
Changes in projector settings take effect upon restarting.
When this is set to On, the following functions are not available.
• Epson Web Control
• Message Broadcasting (EasyMP Monitor plugin)
Control4 SDDP
Set to On if you want to enable the acquisition of the device
information by
Control4
®
Simple Device Discovery Protocol
(SDDP)
g
.
List of Functions
153