Operation Manual

Connecting an HDBaseT Transmitter

Connect the optional HDBaseT Transmitter with a commercially available 100BASE-TX LAN cable.

s "Optional Accessories" p.217

HDBaseT

• Make sure you read the User's Guide supplied with the HDBaseT Transmitter carefully before use.

• For the LAN cable, use an HDBaseT Alliance-recommended STP cable (straight) of category 5e or higher. However, operation is not guaranteed for all

input/output devices and environments.

• When connecting or disconnecting the LAN cable, make sure you turn off the power for the projector and the HDBaseT Transmitter.

• When performing Ethernet communication or serial communication, or when using the wired remote control via HDBaseT port, set Control Communications

to On from the Configuration menu.

s Extended - HDBaseT - Control Communications p.142

Note that when Control Communications is set to On, the projector's LAN port, RS-232C port, and Remote port are disabled.

• When using the Extron XTP transmitter or switcher, connect to the projector's HDBaseT port. Set Extron XTP to On (Standby Mode and Control

Communications are automatically set to On).

s Extended - HDBaseT - Extron XTP p.142

Connecting Equipment