Technical data
Table Of Contents
- Introduction
- Set Initial Conditions (SIC) Command
- IBM Emulation Mode Printer Commands
- Control Codes
- Escape Sequences
- Printer Command Parameters
- Command Structure
- Printer Command Quick Reference (IBM Emulation Mode)
- Selecting a Character Set
- Select Code Page
- Print From Code Page
- Download a Character Set
- Select Global Font
- Select Print Type Style
- Set Print Quality
- Graphics Print Modes
- Horizontal Movement
- Line Control
- Vertical Tabulation
- Line Spacing
- Set Top of Form and Page Length
- Printer Control
- Epson Emulation Mode Printer Commands
- OKI Microline Emulation Mode Printer Commands
- Using the Printer Interface
- Downloading Characters and Fonts
- Barcodes
- Code Pages
- Glossary
- Index
119
Section 7: Downloading Characters and Fonts
To replace the ampersand (’&’) symbol, use the following example to download
and print the copyright © symbol.
<x
1B3D - command prefix=’ESC =’ - download character
3200 - count - x0032, 50
15 - Type=NLQ II
26 - Start code=’&’
00 - attribute byte 1=ascender, not line-drawing, not
graphics character
00 - attribute byte 2=not used for download
00 00 - column 1
1C 18 - column 2
00 24 - column 3
22 00 - column 4
00 00 - column 5
00 42 - column 6
08 18 - column 7
55 00 - column 8
41 24 - column 9
41 24 - column 10
41 24 - column 11
41 24 - column 12
41 24 - column 13
41 24 - column 14
41 24 - column 15
41 00 - column 16
14 00 - column 17
00 42 - column 18
00 00 - column 19
22 00 - column 20
00 24 - column 21
1C 18 - column 22
00 00 - column 23
1B4907 - select download font. This is a download NLQ II
character (©).
>&