Technical data
Table Of Contents
- Introduction
- Set Initial Conditions (SIC) Command
- IBM Emulation Mode Printer Commands
- Control Codes
- Escape Sequences
- Printer Command Parameters
- Command Structure
- Printer Command Quick Reference (IBM Emulation Mode)
- Selecting a Character Set
- Select Code Page
- Print From Code Page
- Download a Character Set
- Select Global Font
- Select Print Type Style
- Set Print Quality
- Graphics Print Modes
- Horizontal Movement
- Line Control
- Vertical Tabulation
- Line Spacing
- Set Top of Form and Page Length
- Printer Control
- Epson Emulation Mode Printer Commands
- OKI Microline Emulation Mode Printer Commands
- Using the Printer Interface
- Downloading Characters and Fonts
- Barcodes
- Code Pages
- Glossary
- Index
155
Section 8: Barcodes
Examples:
Valid EAN-13 command:
Since the b0 bit of the c parameter has a value of 0 (check digit by host/
software), there must be 13 data characters (x0D) specified in the Data Transfer
Command.
<x
B5B66 - barcode setup command prefix
0600 - setup data length (low byte first) -
x0006, 6
B2 - barcode type = EAN-13
00 - module width = default
00 - space width adjustment = default
4003 - height (low byte first) - x0340 =
832 = 0.385 inches
00 - control byte: check digit from
host, print human readable
character, center flag character
1B5B70 - barcode data transfer command
prefix
0D00 - data transfer length (low byte
first) - x000D, 13
>2359458890256 ...