Technical data
Table Of Contents
- Introduction
- Set Initial Conditions (SIC) Command
- IBM Emulation Mode Printer Commands
- Control Codes
- Escape Sequences
- Printer Command Parameters
- Command Structure
- Printer Command Quick Reference (IBM Emulation Mode)
- Selecting a Character Set
- Select Code Page
- Print From Code Page
- Download a Character Set
- Select Global Font
- Select Print Type Style
- Set Print Quality
- Graphics Print Modes
- Horizontal Movement
- Line Control
- Vertical Tabulation
- Line Spacing
- Set Top of Form and Page Length
- Printer Control
- Epson Emulation Mode Printer Commands
- OKI Microline Emulation Mode Printer Commands
- Using the Printer Interface
- Downloading Characters and Fonts
- Barcodes
- Code Pages
- Glossary
- Index
Section 8: Barcodes
164
data character set:
Examples:
Valid Interleaved 2of5 command:
Since the b0 bit of the c parameter has a value of 01 (check digit by printer), note
the 0 character added to the barcode above.
Character Hex
’0’ x30
’1’ x31
’2’ x32
’3’ x33
’4’ x34
’5’ x35
’6’ x36
’7’ x37
’8’ x38
’9’ x39
<x
1B5B66 - barcode setup command prefix
0600 - setup data length (low byte first) -
x0006, 6
B6 - barcode type = Interleaved 2of5
00 - module width = default
00 - space width adjustment = default
1003 - height (low byte first) - x0310 = 784 =
0.363 inches
01 - control byte: check digit from host,
print human readable character
1B5B70 - barcode data transfer command prefix
0400 - data transfer length (low byte first) -
x0004, 4
>2359 ...