Technical data
Table Of Contents
- Introduction
- Set Initial Conditions (SIC) Command
- IBM Emulation Mode Printer Commands
- Control Codes
- Escape Sequences
- Printer Command Parameters
- Command Structure
- Printer Command Quick Reference (IBM Emulation Mode)
- Selecting a Character Set
- Select Code Page
- Print From Code Page
- Download a Character Set
- Select Global Font
- Select Print Type Style
- Set Print Quality
- Graphics Print Modes
- Horizontal Movement
- Line Control
- Vertical Tabulation
- Line Spacing
- Set Top of Form and Page Length
- Printer Control
- Epson Emulation Mode Printer Commands
- OKI Microline Emulation Mode Printer Commands
- Using the Printer Interface
- Downloading Characters and Fonts
- Barcodes
- Code Pages
- Glossary
- Index
Section 8: Barcodes
170
Since the v1, v2 values for the bar length are ignored for POSTNET, 00 00 is an
acceptable bar length specification.
Invalid POSTNET command:
The ’-’ (dash) is an invalid character for POSTNET.
<x
1B5B66 - barcode setup command prefix
0600 - setup data length (low byte first) -
x0006, 6
B9 - barcode type = POSTNET
00 - module width = default
00 - space width adjustment = default
0000 - height (low byte first) - ignored for
POSTNET
00 - control byte: no functions selected
1B5B70 - barcode data transfer command prefix
0A00 - data transfer length (low byte first) -
x000A, 10
>40511-876 ...