Technical data
Table Of Contents
- Introduction
- Set Initial Conditions (SIC) Command
- IBM Emulation Mode Printer Commands
- Control Codes
- Escape Sequences
- Printer Command Parameters
- Command Structure
- Printer Command Quick Reference (IBM Emulation Mode)
- Selecting a Character Set
- Select Code Page
- Print From Code Page
- Download a Character Set
- Select Global Font
- Select Print Type Style
- Set Print Quality
- Graphics Print Modes
- Horizontal Movement
- Line Control
- Vertical Tabulation
- Line Spacing
- Set Top of Form and Page Length
- Printer Control
- Epson Emulation Mode Printer Commands
- OKI Microline Emulation Mode Printer Commands
- Using the Printer Interface
- Downloading Characters and Fonts
- Barcodes
- Code Pages
- Glossary
- Index
177
Section 8: Barcodes
Invalid Code 128 command:
The first byte of the data string defines the character set and must be either ’A’,
’B’ or ’C’. ’4’ is an invalid first byte.
<x
1B5B66 - barcode setup command prefix
0600 - setup data length (low byte first) -
x0006, 6
BA - barcode type = Code 128
00 - module width = default
00 - space width adjustment = default
0404 - height (low byte first)
00 - control byte: check digit from host, human
readable character
1B5B70 - barcode data transfer command prefix
0500 - data transfer length (low byte first) -
x0005, 5
>49545 ...