Technical data
Table Of Contents
- Introduction
- Set Initial Conditions (SIC) Command
- IBM Emulation Mode Printer Commands
- Control Codes
- Escape Sequences
- Printer Command Parameters
- Command Structure
- Printer Command Quick Reference (IBM Emulation Mode)
- Selecting a Character Set
- Select Code Page
- Print From Code Page
- Download a Character Set
- Select Global Font
- Select Print Type Style
- Set Print Quality
- Graphics Print Modes
- Horizontal Movement
- Line Control
- Vertical Tabulation
- Line Spacing
- Set Top of Form and Page Length
- Printer Control
- Epson Emulation Mode Printer Commands
- OKI Microline Emulation Mode Printer Commands
- Using the Printer Interface
- Downloading Characters and Fonts
- Barcodes
- Code Pages
- Glossary
- Index
Section 8: Barcodes
182
• When the m parameter is set to 1 (m = 1), the printer does not print the
human readable character.
Example:
Although the c parameter has a value of x00, which tells the printer to
print the human readable character, the m parameter has a value of x01,
which causes the b1 bit value of the c parameter to be ignored. No human
readable character is printed.
• Be cautious when sending commands to change the page length and mar-
gins. The barcode print area cannot exceed the page length, bottom mar-
gin, or right margin.
<x
1B5B66 - barcode setup command prefix
0600 - setup data length (low byte first) -
x0006, 6
B4 - barcode type = Code 39
01 - module width = 1 = 0.017 inches for 248x
0.012 inches for 249x
00 - space width adjustment = default
3804 - height (low byte first) - x0438= 0.50
inches
00 - control byte: check digit by host, print
human readable character
>