Technical data
Table Of Contents
- Introduction
- Set Initial Conditions (SIC) Command
- IBM Emulation Mode Printer Commands
- Control Codes
- Escape Sequences
- Printer Command Parameters
- Command Structure
- Printer Command Quick Reference (IBM Emulation Mode)
- Selecting a Character Set
- Select Code Page
- Print From Code Page
- Download a Character Set
- Select Global Font
- Select Print Type Style
- Set Print Quality
- Graphics Print Modes
- Horizontal Movement
- Line Control
- Vertical Tabulation
- Line Spacing
- Set Top of Form and Page Length
- Printer Control
- Epson Emulation Mode Printer Commands
- OKI Microline Emulation Mode Printer Commands
- Using the Printer Interface
- Downloading Characters and Fonts
- Barcodes
- Code Pages
- Glossary
- Index
Section
Section 2: Set Initial Conditions (SIC) Command
21
2
Set Initial
Conditions (SIC)
Command
The SIC command sets the printer to the default values that were set at the
factory or to user-defined defaults.
SIC Command Format
Use the following format:
Ln is the number of parameters plus 2. Hn is 0.
The decimal and hexadecimal digits for the printer command appear below the
printer command format.
Format ESC [ K Ln Hn init ID p1...p22
Decimal 27 91 75 Ln Hn
Hex 1B5B4BLnHn