Technical data
Table Of Contents
- Introduction
- Set Initial Conditions (SIC) Command
- IBM Emulation Mode Printer Commands
- Control Codes
- Escape Sequences
- Printer Command Parameters
- Command Structure
- Printer Command Quick Reference (IBM Emulation Mode)
- Selecting a Character Set
- Select Code Page
- Print From Code Page
- Download a Character Set
- Select Global Font
- Select Print Type Style
- Set Print Quality
- Graphics Print Modes
- Horizontal Movement
- Line Control
- Vertical Tabulation
- Line Spacing
- Set Top of Form and Page Length
- Printer Control
- Epson Emulation Mode Printer Commands
- OKI Microline Emulation Mode Printer Commands
- Using the Printer Interface
- Downloading Characters and Fonts
- Barcodes
- Code Pages
- Glossary
- Index
35
Section 3: IBM Emulation Mode Printer Commands
located in the code page tables beginning on page 188.
Print One Character
Use this command to print a character from the All Characters Chart of a Code
Page (see “Code Pages” on page 187).
Usage Note
Substitute the decimal or hexadecimal digit of the character you want to print
for the variable n.
Download a Character Set
This command downloads a character set to the printer and starts a character
font image download. Up to 256 consecutive characters can be downloaded in
each ESC = sequence.
To download fonts, download must be enabled in the Setup menu.
Usage Notes
count low/count high
The number of bytes of data being downloaded starting with the printer id byte.
id
A 1-byte number identifying the printer.
Format ESC ^ n
Decimal 27 94 n
Hex 1B 5E n
Format ESC = count low/high id start low/high data
Decimal 27 61 count low/high id start low/high data
Hex 1B 3D count low/high id start low/high data
Printer
Dec Hex
2480 Plus
182 B6
2481 Plus
184 B8
2490 Plus
183 B7
2491 Plus
185 B9