Technical data
Table Of Contents
- Introduction
- Set Initial Conditions (SIC) Command
- IBM Emulation Mode Printer Commands
- Control Codes
- Escape Sequences
- Printer Command Parameters
- Command Structure
- Printer Command Quick Reference (IBM Emulation Mode)
- Selecting a Character Set
- Select Code Page
- Print From Code Page
- Download a Character Set
- Select Global Font
- Select Print Type Style
- Set Print Quality
- Graphics Print Modes
- Horizontal Movement
- Line Control
- Vertical Tabulation
- Line Spacing
- Set Top of Form and Page Length
- Printer Control
- Epson Emulation Mode Printer Commands
- OKI Microline Emulation Mode Printer Commands
- Using the Printer Interface
- Downloading Characters and Fonts
- Barcodes
- Code Pages
- Glossary
- Index
57
Section 3: IBM Emulation Mode Printer Commands
• ESC R (Set Default Tabulation Stops) and ESC B 0 will clear all vertical tab
stops.
• Set the tabulation stops in ascending order (n1.....n64).
• The last digit in the sequence must be a 0 to terminate the command.
Line Spacing
Set Line Spacing to 1/8 Inch
This command (ESC zero) sets the line spacing at 1/8 inch between each line,
which is 8 lines per inch (lpi).
Set Line Spacing to 7/72 Inch
This command sets the line spacing at 7/72 inch between each line, which
is 10.3 lpi.
Activate Line Spacing for Text
This command activates the line spacing designated by the Set Line Spacing for
Text (ESC A) printer command.
Format ESC 0
Decimal 27 48
Hex 1B 30
Format ESC 1
Decimal 27 49
Hex 1B 31
Format ESC 2
Decimal 27 50
Hex 1B 32