Technical data
Table Of Contents
- Introduction
- Set Initial Conditions (SIC) Command
- IBM Emulation Mode Printer Commands
- Control Codes
- Escape Sequences
- Printer Command Parameters
- Command Structure
- Printer Command Quick Reference (IBM Emulation Mode)
- Selecting a Character Set
- Select Code Page
- Print From Code Page
- Download a Character Set
- Select Global Font
- Select Print Type Style
- Set Print Quality
- Graphics Print Modes
- Horizontal Movement
- Line Control
- Vertical Tabulation
- Line Spacing
- Set Top of Form and Page Length
- Printer Control
- Epson Emulation Mode Printer Commands
- OKI Microline Emulation Mode Printer Commands
- Using the Printer Interface
- Downloading Characters and Fonts
- Barcodes
- Code Pages
- Glossary
- Index
Section 6: Using the Printer Interface
98
Serial Interface Cable (RS-232C)
The recommended RS-232C serial cable is 50 feet long. This cable works with
the IBM PS/2 series and other compatible host systems using a 25-pin male
connector. The maximum total capacitance of the cable and the connector
should be less than 2500 pF, or it will delay the signal transition by more than
4%.
Following is a diagram of the serial cable (Lexmark part number 1038693 (15.24
m or 50 ft.)).