Operation Manual

Troubleshooting
99
Check Remedy
Is WirelessHD set to Off? When WirelessHD is set to Off from the Configuration menu,
projection is not possible for WirelessHD input signals. Set Wire‐
lessHD to On, and then press the
button. s Settings -
WirelessHD p.79
Are signals being received within the Wire‐
lessHD transmission range?
Check the range within which the WirelessHD's transceiver can
communicate, and view within that range.
s p.61
Is the supplied WirelessHD Transmitter
turned on?
Check the power lamp on the WirelessHD Transmitter. If there is
no power being supplied, make sure the connector for the AC
adapter is securely connected, and then turn on the power
switch.
Is the WirelessHD indicator for the supplied
WirelessHD Transmitter off?
No signal is output from the AV device connected to the Wire‐
les sHD Tra nsm itt er. Che ck t hat the c abl es fro m th e AV d evi ce and
the WirelessHD Transmitter are securely connected.
When you last viewed the images that had been output to a
monitor device, such as television, via the Output port, the im‐
ages will be projected on the same monitor device as the last one
the next time the projector is turned on. To cancel the setting,
press the
button (switch output) on the remote control
while pointing it at the WirelessHD Transmitter.
s p.63
Is the Link indicator for the supplied Wire‐
lessHD Transmitter off?
The WirelessHD cannot communicate with the projector. Check
the range within which the WirelessHD's transceiver can com‐
municate, and setup within that range.
Has dust collected in the WirelessHD Trans‐
mitter's vent?
Has dust collected in the WirelessHD Transmitter's vent? Com‐
munication may not be possible if dust has collected in the vent.
Install the projector so that dust does not collect in the vent.
Are the projector and the WirelessHD Trans‐
mitter facing the correct way?
Setup the projector and the WirelessHD Transmitter so that they
are facing each other.
Is "Source: WirelessHD X"/"No Signal" dis‐
played in the lower-left part of the screen?
Check that the AV device connected with the HDMI port on the
WirelessHD Transmitter is turned on. The input signal number
displayed on the screen is the same as the HDMI port number.
In addition, unless HDMI Link is set to On, the connected device
does not turn on. Set HDMI Link to On.
s Settings - HDMI
Link - HDMI Link p.79
WirelessHD audio is not output correctly.
Check Remedy
Is audio output when the WirelessHD is con‐
nected?
When connecting a device, such as a sound bar, to the Optical
Audio-Out port on the WirelessHD Transmitter to output audio
from there, set Audio Out Device to WirelessHD Transmitter.
The connected sound bar must be set to surround sound. To
output audio from the projector, set it to Projector.
s Set‐
tings - HDMI Link - Audio Out Device p.79
Interference, distortion, or interruption appear in WirelessHD
Check Remedy
Are signals being received within the Wire‐
lessHD transmission range?
Check the range within which the WirelessHD's transceiver can
communicate, and view within that range.
s p.61