Operation Manual

Basic Operations
26
If the Target Image is not Projected
If the image is not projected, you can change the source using one of the following methods.
Remote control Control panel
Press the button for the target port.
Press the
button and select the target port.
Press the
button to confirm the selection.
c
•
For video equipment, start playback first and then change the source.
•
If the color looks unnatural when changing to a Video or Component source, check that the port you
have connected to is the same as the Input Signal.
s Extended - Input Signal - Video Signal/
Component p.73
Turning Off
a
Turn off the connected equipment.
c
When Power Off Link is set to
On in the HDMI Link menu,
turning off HDMI CEC compatible
equipment may also turn off the
projector.
s Settings - HDMI
Link - Power Off Link p.70
b
Press the button on the remote
control or the projector's control
panel.
Remote control Control panel
A confirmation message is displayed.
c
Press the button again.
Projection ends, and the lens shutter closes
automatically.
c
When Standby Confirmation is
set to Off, you can turn off the
projector by pressing the
button on the remote control
once.
s Extended - Display -
Standby Confirmation p.73
d
Wait until cool-down is complete.
The operation indicator on the projector's
control panel stops flashing.
e
Disconnect the power cord.
c
If the power cord is connected,
some electricity is consumed even
if no operations are made.