Operation Manual
Useful Functions
53
Name Function
b
Input button
Changes to the image from each input port.
This performs the same function as the
button for WiHD Transmit‐
ter control on the lower section of the remote control.
c
Output button
Switches the output image to the Wireless or Output port.
This performs the same function as the
button for WiHD Transmit‐
ter control on the lower section of the remote control.
d
Main power switch
Turns the main power for the transmitter on or off.
e
AC adapter port
Connects the AC adapter.
f
Optical Audio-Out port
Connects to audio devices equipped with an optical digital audio input port.
g
HDMI Output port
Connects to other output devices, such as televisions. You can switch the
output using the Output button.
h
HDMI Input port
Connects to the AV device you want to playback. You can switch the input
image using the Input button.
The HDMI5 port of the unit meets the MHL standards. You can play content
from smartphones or tablets connected with an MHL cable.
i
3D Glasses charging port
Connects a USB cable to charge the 3D Glasses.
j
Setup button
This is the button on the back of the WirelessHD Transmitter. It is used for
setting the WirelessHD Transmitter. This is not normally used.
k
t
indicator
(orange/green)
Lit when the WirelessHD Transmitter is on. Lit orange when standing by,
and green when operating (receiving or transmitting images).
l
WiHD indicator
(orange)
Indicates the communication status for the WirelessHD.
•
Lit when wirelessly transmitting images to the projector.
•
Off when outputting to the Output port.
m
Link indicator
(orange)
Indicates the connection status with the projector.
•
On when projecting images from the projector.
•
Flashes when searching for a projector.
•
Flashes slowly when standing by in power saving status.
c
•
The receiver is located within the intake vent of the projector and therefore cannot receive any signals
directly from the rear. Set up so that the front of the projector is facing the WirelessHD Transmitter.
Also, make sure that the air intake vent on the left-hand side of the projector is not covered.
•
Place the WirelessHD Transmitter on a level surface facing towards the projector.
•
You can view the signal strength from the WirelessHD settings menu. s Settings - WirelessHD -
Reception p.70
Setting the WirelessHD Transmitter
a
Set up the WirelessHD Transmitter
connected to the projector so that
they are facing each other.
s
p.56