Operation Manual

Useful Functions
59
Switching the image source
You can switch the image source for the AV device connected to the WirelessHD Transmitter. When switching,
each input source is displayed on one screen as a preview. This allows you to switch easily between image
sources even when two or more devices are connected using HDMI.
The projector uses Insta Prevue Technology from Silicon Image, Inc.
Switching the source
a
Point the remote control at the
WirelessHD Transmitter, and then
press the
button.
Remote control WirelessHD Trans‐
mitter
Displays the sub-screen for the connected
device.
b
The target screen changes each time
you press the
button.
c
After selecting the target screen,
please wait for a moment.
The projected image is switched.
Displaying as a sub-screen
a
Point the remote control at the
WirelessHD Transmitter, and then
press the
button.
Displays the sub-screen for the connected
device.
b
When switching between the sub-
screen and the main screen, press and
hold down the
button (for
approximately 3 seconds) until the
screen changes.
c
To close the sub-screen, press the
button again.
The projected image is switched.