Operation Manual

Configuration Menu

Extended menu

Function Menu/Settings Explanation

Operation

Direct Power On On, Off You can set up the projector so that projection

starts as soon as the power cord is plugged in

without any button operations.

Note that when this is set to On, projection starts

if power is restored after a blackout or other

power outage and the power cord is still plugged

into the projector.

Sleep Mode Off, 5min., 10min.,

30min.

If the set time is exceeded and no signal is input,

the projector is automatically turned off and en‐

ters standby mode. When set to Off, the projec‐

tor never enters sleep mode. When in standby

mode, press the

button on the remote con‐

trol or the

button on the control panel to

start projection.

Illumination On, Off

Set this to Off if the light from the indicators on

the control panel bothers you when watching a

movie in a dark room.

Trigger Out On, Off

Set the Trigger Out function to communicate the

projector's power on status and so on to external

devices.

When set to Off, no voltage is output from the

Trigger out port.

When set to On or Power, voltage is output from

the Trigger out port when the projector is on.

For Anamorphic Wide, when the projector is on

and Aspect is set to Anamorphic Wide or Horiz.

Squeeze, voltage is output from the Trigger

out port.

If you change this setting, the new setting will

take effect the next time you turn the projector

on.

Off, Power, Ana‐

morphic Wide

High Altitude Mode On, Off

Set this to On if you are using the projector above

an altitude of 1500 meters.