Operation Manual

Configuration Menu
75
Memory menu
Function Explanation
Load Memory
Loads settings saved using the Save Memory function. s p.43
This cannot be selected if you have not saved any settings with the Save Mem‐
ory function.
Save Memory
Saves certain Image and Signal settings to memory. s p.42
Erase Memory
Erases settings saved to memory that you no longer need. s p.43
Rename Memory
Renames a saved memory. s p.43
Info menu
Function Explanation
Lamp Hours
Displays the cumulative lamp operating time
*
.
Source
Displays the source name for the connected equipment currently being projec‐
ted.
Input Signal
Displays the content of Input Signal set in the Signal menu according to the
source.
Resolution
Displays the resolution.
Scan Mode
Displays the scan mode.
Refresh Rate
Displays the refresh rate.
3D Format
Displays the 3D format of the signal input during 3D projection (Frame Packing,
Side by Side, or Top and Bottom).
Sync Info
Displays the image signal information.
This information may be needed if service is required.
Deep Color
Displays deep color.
Video Signal
Displays the settings for Video Signal in the Extended menu.
Status
This is information about errors that have occurred on the projector.
This information may be needed if service is required.
Serial Number
Displays the projector's serial number.
Version
Displays the firmware version of the projector.
*
The cumulative use time is displayed as "0H" for the first 10 hours. 10 hours and above is displayed as "10H",
"11H", and so on.
Reset menu
Function Explanation
Reset All
Resets all items in the Configuration menu to their default settings.
The following items are not reset to their defaults: Input Signal - Component,
Panel Alignment, Lamp Hours, Language, Save Memory.
Reset Memory
Erases all settings saved using the Save Memory function.
Reset Lamp Hours
Resets the cumulative lamp hours use time to 0 H. Reset when you replace the
lamp.