Operation Manual

Troubleshooting
79
Indicator status during normal operation
: Lit : Flashing : Off
Indicators Status Remedy
Standby condition
When you press the button on the remote control, or the
button on the control panel, projection starts after a short
wait.
(blue)
Warm-up in progress
Warm-up time is about 30 seconds.
The power-off operation is disabled while the projector is warm‐
ing-up.
Cool-down in pro‐
gress
All operations are disabled while the projector is cooling-down.
The projector enters standby condition when cool-down is com‐
plete. If for any reason the power cord is disconnected during
cool-down, wait until the lamp has cooled down sufficiently
(about 10 minutes), reconnect the power cord, and then press
the
button on the remote control, or the button on the
control panel.
(blue)
Projection in pro‐
gress
The projector is operating normally.
c
•
Under normal operating conditions, the o and m indicators are off.
•
When the Illumination function is set to Off, all indicators are off under normal projection conditions.
s Extended - Operation - Illumination p.73