Projector User Manual
Table Of Contents
- Projector Features
- Contents
- Before Using the Projector
- Part Names and Functions
- Before Using the Remote Control
- Installation
- Inserting and Removing Cards (EMP-765/755 only)
- Connecting to a Computer
- Connecting to a Video Source
- Playing Sound from Video Equipment
- Playing Sound from External Speakers (EMP-765/755 only)
- Connecting USB Devices (Digital Camera, Hard Disk Drive or Memory Devices) (EMP-765/755 only)
- Preventing theft (Password Protect)
- Basic Operations
- Advanced Operations
- Troubleshooting
- Appendices
102
Maintenance
User’s Guide
Take out the lamp.
Hold the lamp as shown in the illustration below and lift it up
and out of the projector.
If the lamp is broken replace it with a new lamp, or contact your
local dealer for further advice. If replacing the lamp yourself,
be careful to avoid pieces of broken glass.
Install the new lamp.
Insert the new lamp so that the lamp fits the place correctly and
once it is fully inserted, tighten the two screws.
Install the lamp cover.
Insert the two cover tabs into the projector, and then press the
other side of the lamp cover until it clicks into place.
4
5
6
TIP
•Install the lamp securely. If the lamp cover is removed, the lamp
turns off automatically as a safety precaution. Moreover, the lamp
will not turn on if the lamp or the lamp cover is not installed
correctly.
•The lamp contains mercury. Dispose of used lamps properly in
accordance with your local regulations.