Service manual

2-22
EMP-S3
SEIKO EPSON Revision:B
 Lamp or Temp indicator flashes orange: Warning
On Blink Off
Lamp timer fail-
ure Lamp out
Take out the lamp and check if it is broken.
If the lamp is not broken, put it back in and then turn
the power on. If the lamp still does not turn on, replace
it with a new lamp.
If this does not solve the problem, stop using the pro-
jector and disconnect the power cable from the electri-
cal outlet. Then contact your dealer or the nearest
address provided in the "International Warranty Condi-
tions" section of the Safety Instructions/World-Wide
Warranty Terms booklet
If the lamp is broken replace it with a new lamp, or
contact your local dealer for further advice to. If
replacing the lamp yourself, be careful to avoid pieces
of broken glass. (Projection cannot be carried out until
the lamp is replaced.)
Check that the lamp and the lamp cover are securely
installed. If the lamp or lamp cover is not securely
installed, the lamp will not switch on.
Indicator Status Projector Status Problem and Remedy
High-speed
cooling in
progress
This is not an abnormality, but if the temperature rises
too high again, projection will stop automatically.
• Check that the air filters and air exhaust vent are
clear and that they are not up against a surface such
as a wall.
• If the air filters are clogged, clean or replace them.
Lamp replace-
ment notifica-
tion
Replace the lamp with a new one.
If you continue to use the lamp after it has passed the
replacement period, the possibility that the lamp may
break will increase. Replace the lamp with a new one
as soon as possible. The Power indicator status will
vary depending on the projector status at the time.
Indicator Status Projector Status Problem and Remedy
Red
Red
Power
Red
Orange
Power
Orange
Power