Service manual

ManualsBrandsEpson ManualsProjectorEMP-S3

5-2

EMP-S3

SEIKO EPSON Revision:B

5.1 AS (After Service) Menu

The AS (After Service) menu provides information and settings that are not displayed on the

standard menu.

5.1.1 How To Display the AS (After Service) Menu

Press the Menu button on either the remote control or the projector's control panel for at least 5

seconds. Within 4 seconds after pressing the Menu key, hit these buttons in order shown below

to display AS menu.

Esc → Esc → Tele → Wide

 When the video source is Computer, RGB-Video, YCbCr, YPbPr, the following screen

appears.

C A U T I O N

The contents of this chapter are for use only by Epson Authorized Servicers, and

are not to be disclosed to others without the express written consent of Epson.

XXXXXXXXXXXXXX

Input Signal

: XXXXXXXXXXXXXXXXXX

Frequency

: H ---.---KHz

: V ---.---Hz

Sync Polarity

: H ---------

: V ---------

Sync Mode

: --------------

Detected Comp Mode

: XXXXXXXXXXXXXX

Total Operation Time

: 65535H

Lamp Operation Time

: 65535H

Lamp Op. Time (H/L)

: 65535H/65535H

Lamp Replacement

: 65535Times

Lamp ON

: 65535Times

Cool Down Complete

: 65535Times

Fatal Error

: T99 L99 I99

Engine Type

: XXXXXXXX

0Z00023041XV111

---------------------

0Z1XV100

The last four digits show the PW

firmware version.

The last four digits show the Easy

MP firmware version.

The last four digits show the Y43

firmware version.

• Fatal Error: Abnormal termination

counter

Displays the number of times of each

of the following abnormal termina-

tions.

T: Temperature problem

L: Lamp problem

I: Internal problem

(Same as for S-Video and Video)