User's Manual

Removing a Drive From a Horizontal Bay
This section describes how to remove a drive from a horizontal
drive bay. Although the illustrations show a drive in the lower
bay, you can use these same instructions to remove a drive
from the upper bay.
Follow these steps to remove a drive from a horizontal bay:
1.
Disconnect the drive ribbon cable and power supply cable
from the back of the drive. Grasp the cable connectors and
pull them straight out from the connectors on the drive so
you do not bend the pins; do not pull on the cables.
2.
Remove the two retaining screws securing the drive to the
drive bay. Then grasp the front of the drive and pull it
completely out of the bay.
5-26 Installing and Removing Drives