User's Manual

3.
Remove the memory chip from its package.
4.
Position the chip over the socket, as shown below. Make sure
the notch in the chip aligns with the arrow that identifies
pin 1 on the socket. (A notch in the outline for the socket
drawn on the system board also identifies pin 1.)
5.
Gently press the chip into the socket. If it does not go in
smoothly, remove it and try again.
6.
Replace any option cards you removed. See page 4-15 for
instructions.
7.
Now run SETUP as described in Chapter 2 so that your
system recognizes the increased memory.
Installing and Removing Options
4-21