User's Manual
7.
To
insert
a
hard
disk
drive,
align
the
guiderails
on
each
side
of
the
drive
with
the
notches
on
each
side
of
the
drive
bay
and
slide
the
drive
all
the
way
into
the
bay,
as
shown
below.
Secure
the
guiderails
to
the
computer
case
with
the
two
retaining
screws.
notch
guiderail
Connecting the Cables
To
connect
the
drive
to
the
computer,
you
need
to
connect
two
cables:
a
drive
ribbon
cable
and
a
power
supply
cable.
The
steps
below
describe
how
to
connect
these
cables
to
the
drive.
If
you
are
installing
a
diskette
drive,
follow
step
1
and
then
skip
to
step
3.
If
you
are
installing
a
hard
disk
drive,
start
with
step
2.
1.
Locate
the
diskette
drive
ribbon
cable.
One
end
of
the
cable
is
connected
to
the
system
board.
If
you
are
installing
a
second
diskette
drive
in
the
lower
horizontal
drive
bay,
the
other
end
of
the
cable
is
connected
to
the
top
diskette
drive;
use
the
middle
connector.
If
you
are
installing
a
diskette
drive
in
the
upper
bay,
use
the
free
end
connector.
5-22 Installing and Removing Drives