User's Manual

4. Make sure the holes in the cable connector fit over all the pins
in the system board connector; then push in the cable
connector.
Caution
If you do not correctly align the holes with the pins, you
could severely damage your system board when you
push in the cable connector.
Post-installation Procedures
After you install or remove your drive(s) and replace the
computer’s cover, follow the steps below to make sure your
new configuration works properly:
1. Run the SETUP program to configure your computer for your
new set of drives. See Chapter 2 for instructions.
2. If you installed a non-IDE hard disk drive (which requires a
separate controller card to control it), you need to run the
SETUP program to disable the built-in IDE hard disk drive
interface.
3. You may need to format the drive before you can use it.
(All EPSON-supplied drives are sold already formatted.)
Check the manual that came with the drive to see if it is
already form atted. If not, follow the manufacturer’s
instructions to format the drive.
You also need to format the drive for the operating system you
are using. See your operating system manual for
instructions.
Installing and Removing Drives 5-33