User's Manual

Power-on diagnostics error messages (continued)
Error message Action
DISK BOOT FAILURE, The system found no boot device.
INSERT SYSTEM DISK
AND PRESS ENTER First run the SETUP program and check the boot
sequence settings. If the settings are correct and
you are booting from a hard disk drive, see
“Hard Disk Problems.”
If you are booting from a diskette, make sure the
diskette is bootable: then see “Diskette Problems.”
DISPLAY SWITCH IS
SET INCORRECTLY
DIP switch 4 conflicts with the video options in the
SETUP program. See Chapter 4 for correct DIP
switch settings and Chapter 2 for instructions on
running SETUP.
DISPLAY TYPE HAS
CHANGED SINCE
LAST BOOT
The display adapter has been changed. Run
SETUP. See Chapter 2.
FLOPPY DISK The system was unable to detect a diskette drive
CONTROLLER ERROR controller.
OR NO
CONTROLLER If you have no diskette drive, run SETUP and select
PRESENT none for both diskette drives.
If you have at least one diskette drive, see
“Diskette Drive Problems.”
FLOPPY DISK TYPE IS The installed diskette drive does not match the
SET INCORRECTLY CMOS definition. See “Diskette Drive Problems.”
OR DRIVE ERROR
HARD DRIVE The system was unable to detect the hard disk
CONTROLLER drive controller. See “Hard Disk Problems.”
DIAGNOSTICS ERROR
HARD DRIVE SECTOR Your hard disk drive may be damaged. Contact
VERIFY ERROR the EPSON Connection.
KEYBOARD ERROR Your keyboard may not be connected correctly.
OR NO KEYBOARD See “Keyboard Problems.”
PRESENT
6-4 Troubleshooting