User's Manual

Saving Your Settings and Exiting SETUP
When you leave SETUP, you can either save the settings you
have changed or exit the program without saving any changes.
To save your settings, follow these steps:
1. Press ESC to return to the main SETUP menu.
2. Select option 6, SAVE settings and exit, and
press Enter. You see this message:
Write to CMOS RAM and exit (Y/N)?
3. Press Y and Enter. The system reboots.
4. If you have just run SETUP for the first time, see “Post-SETUP
Procedures,” below.
To exit SETUP without saving the settings, select option 7,
Exit without saving setting. The system reboots with
your original settings.
Note
If your computer detects a problem in your SETUP
configuration, you may see an error message and a prompt
to run SETUP when it is rebooting. Follow the instructions
on the screen to run SETUP and correct the problem.
You may also see an error message when your computer is
rebooting if you have not installed your operating system on
the hard disk and you did not insert a system diskette in
drive A. If you receive this error message, follow the
instructions in your operating system manual to install it.
Running the SETUP Program 2-17