User's Manual
To
reset
the
computer,
the
operating
system
must
be
either
on
the
hard
disk
or
on
a
diskette
in
drive
A. If you
are
using
MS-DOS,
hold
down
Ctrl
and
Alt and
press
Delete.
The
screen
goes
blank
for
a
moment
and
then
the
computer
should
reload
your
operating
system.
If
resetting
the
computer
does
not
correct
the
problem,
you
probably
need
to
turn
it
off
and
reboot
it.
Remove
any
diskette(s)
from
the
diskette
drive(s).
Turn
off
the
computer
and
wait
20
seconds.
If you
do
not
have
a
hard
disk,
insert
the
system
diskette
in
drive
A.
Then
turn
on
the
computer.
Using
a
Pass
word
If
you
set
a
system
access
password
when
you
ran
the
SETUP
program,
you
must
enter
it
every
time
you
turn
on
or
reset
the
computer.
Follow
these
steps
to
use
your
password:
1.
If you
do
not
have
a
hard
disk,
insert
your
system
diskette
in
drive
A.
2.
Turn
on
or
reset
the
computer.
You
see
the
following
prompt:
Enter
Password:
3.
Type
your
password
and
press
Enter
If
you
type
the
password
incorrectly,
the
computer
will
beep
and
allow
you
to
retype
it.
After
you
type
the
password
correctly
and
press
Enter,
the
computer
loads
the
operating
system
and
displays
the
command
prompt.
Note
If
you
do
not
know
the
correct
password,
see
“Password
Problems”
in
Chapter
6.
Using Your Computer 3-7