User's Manual

7. Make sure the pins in the processor chip are directly over the
holes in the socket. Then gently push the microprocessor
straight into the socket.
8. Secure the chip in the socket by pressing the ZIF handle back
to the closed position.
9. If you are installing SX2, DX, DX2, DX4, or Pentium
OverDrive processors, you must install a heat sink on the
chip. Follow the instructions that came with the heat sink or
processor.
10. If you are upgrading from an SX-based processor to a DX- or
Pentium-based processor, you need to change the jumper
setting of Jl to position A. You may also need to change
DIP switch settings to match the speed of your new
processor. See the table on page 4-7 for more information.
11. Replace your video card and any other option cards you
removed. See page 4-14 for instructions.
4-22
Installing and Removing Options