User's Manual

It is best to install your computer’s first hard disk drive in the
vertical drive bay. If you add a second hard disk drive or
diskette drive, use the lower horizontal bay.
How to Use This Chapter
To install or remove a drive, first remove the computer’s cover
as described on page 4-4. Then see the table below for
instructions you should follow next in this chapter.
To
Install a hard disk drive
Install a diskette drive or other
device in a horizontal drive bay
Remove a diskette drive or
other device from a horizontal
drive bay
Remove a hard disk drive from
the vertical bay
See
“Setting the Hard Disk Drive Jumpers”
on page 5-4
Page 5-16
Page 5-27
Page 5-14
After you install or remove your drive(s), replace the
computer’s cover as described on page 4-23. Then see
“Post-installation Procedures” on page 5-33 for additional steps
you may need to perform.
Installing and Removing Drives 5-3