Installation guide

Note

The label you assign to a device (e.g. “CABLE”) is what you see on the projection screen when you’re selecting

sources.

You can’t select the same label for different inputs. If the label you want is currently selected on another unused

input, change the label on the unused input to free up that label.

7 In the right column of the same row (under Audio Input), select the name of the port to which you’ve

connected the audio cable.

For example: If you’ve connected a cable box to the HDMI1 port and the cable box supports HDMI

audio, select

HDMI1 in the Audio Input column. If you’ve connected your equipment to the S-Video port,

select either

Coax, Optical, or Analog in the Audio Input column, depending on the port to which

you’ve connected the audio cable.

Note

Make sure you don’t select the same audio input for different video inputs.

8 When you’re done changing the settings, press the MENU button to exit the menu system.

Enabling the Remote Control

After connecting a new component, you can continue to use its original remote control. However, it may be

more convenient to set up the Ensemble HD remote control to work with it. That way, you only need to use

one remote control.

You enable the Ensemble HD remote control to recognize the new component by entering a setup code. Setup

codes are listed in the back of the User’s Guide. You may have to try out several codes before finding the right

one for your component. Once the correct code is entered, the remote control will automatically create the

appropriate commands in the menu for the new device.

Note

See the User’s Guide for additional ways to customize the remote control.

1 Locate the code table for your product in the back of the User’s Guide. The code numbers are listed by

categories of devices, then by brand.

2 Turn on the component you want to set up. Each time you enter a code, the remote control will try to turn

off your component by sending a power-off command. You will know that you have entered the correct

code when the component turns off.