Quick Start Guide

R4C4450 Quick Reference
Rev.C
A5 size QUICK.FM
7/18/00 Pass 0
R
Proof Sign-off:
ABE K.Tsuno H.Kimura_______
H.Kimura _______
ABE J.Holmes _______
19
1919
19
Print Overrun The required time to process
the print data exceeds the
print engine speed because
the current page is too
complex. Press the Continue
button to resume printing. If this
message appears again, turn
on Page Protect in the
SelecType Config menu.
If you continue to receive this
message when printing a
particular page, try simplifying
the page by limiting the
number of graphics or
reducing the number and size
of fonts.
PS3 Hard Disk full Writing to Hard Disk Drive is no
longer possible as the amount
of space available on Hard
Disk Drive for PostScript3 is full.
Replace Oil Roll No oil is left in the fuser oil roll.
Replace it with a new fuser oil
roll.
Replace
Photocondctr
The photoconductor unit has
reached the end of its service
life. Turn off the printer, then
remove the photoconductor
unit and install the new
photoconductor unit.
Messages Description
Replace Waste T
Box
The waste toner collector has
become full. Replace it with a
new waste toner collector.
Service req
eXXXX
XXXX:
Any number is
indicated.
A controller error or a print
engine error has been
detected. Write down the error
number listed on the display
and turn off the printer. Wait at
least 10 seconds and then turn
it back on. If this error still
occurs, turn off the printer,
unplug the power cord, and
contact a qualified service
person.
Time Exceed Paper was forcibly output
(“blank sheet printing”) as the
print data did not arrive in time
even though the paper was
pre-fed.
Turn Paper
XXX:
The selected
paper source is
indicated.
Paper is loaded incorrectly
(you cannot load paper short-
edge first). Turn the paper 90
degrees and load it (you need
to load long-edge first.)
Messages Description