Transparency Unit for use with EPSON Scanners B813021/B813022
This transparency unit is a high-quality device developed to enable Epson Scanner owners to scan transparencies and slides. By installing this unit on your Epson scanner, you can scan transparencies and slides beautifully, in full color. Also, it is not necessary to remove this unit if you wish to return to scanning normal reflective (paper) documents. Unpacking the Unit When you first open the package, make sure that all the following items are included and that none has been damaged during shipping.
Removing the Shipping Screw To prevent damage during shipping a shipping screw is attached to the transparency unit. Make sure this screw is removed according to the following steps before you attempt to use this unit. 1. Turn the unit so the glass side faces up. 2. Remove the screw from the position shown below. 3. Insert the screw you just removed into the storage-hole in the position shown.
Note: l l Keep the shipping screw in a safe place; you will need it if you should need to transport the scanner. When transporting the scanner, you should remove the transparency unit and reattach the shipping screw. If the unit’s lamp assembly is not in its initial position, you cannot attach the shipping screw. If this happens, reattach the unit to the scanner, close the unit, and turn the scanner on; the unit’s lamp assembly then returns to its initial position.
4. Use a coin to tighten the two screws and secure the transparency unit. 5. Close the transparency unit. 6. Connect the transparency unit’s connector to the option connector on the scanner.
Transparency Document Guide and Reflective Document Mat A transparency document guide and reflective document mat are included with this unit. Use as necessary.
Position transparency documents according to the steps below. 1. Open the transparency unit. 2. Place the transparency document guide on the scanner’s document table. 3. Using the transparency document guide, place the transparency document face down on the scanners glass document table. Align the transparency document with the upper right-hand corner of the transparency document guide. 4. Close the unit. If the reflective document mat is in place, remove it from the transparency unit.
Scanning Normal (Reflective) Documents When you return to scanning normal reflective documents, you should always insert the reflective document mat included with this unit. Also, make sure you remove the transparency document guide from the scanners document table. Insert the reflective document mat as described below. 1. Open the transparency unit. 2. Insert the reflective document mat. 3. Position the reflective document and close the unit.