Start Here Card

ManualsBrandsEpson ManualsPrintersEpson Epson PictureMate Deluxe Viewer Edition Compact Photo Printer

Start Here

Set up your PictureMate and

print–no computer required!

Note: To print from your computer, see Using PictureMate With a

Computer and your CD after completing these steps.

1 Unpack

PictureMate comes with all these items in the box.

Remove all the tape and packing material from PictureMate,

including the plastic film on the photo viewer screen.

Note: If you purchased the optional PictureMate Deluxe Viewer

Edition battery, see Using PictureMate Without a Computer for

instructions. Make sure you install the photo cartridge and plug in

the AC adapter and power cable before installing the battery.

Caution: To avoid damaging your PictureMate,

keep it out of the sun and don’t leave it in your

car or other location where it can get too hot or

too cold.

2 Install the Photo

Cartridge

1 Open the cartridge door on the back of PictureMate.

You see the release lever.

2 Move the lever to the Release position by sliding it

in the direction shown.

3 Shake the photo cartridge a few times in its package,

then unwrap the cartridge.

4 Slide the cartridge straight into the slot, label side up,

until it is fully inserted. Push in both sides evenly to

make sure it is not crooked.

Caution: Make sure both sides of the cartridge are even,

or ink may leak. If either side is sticking out, remove the

cartridge and reinstall it.

5 Move the lever right to the Lock position. If it does

not lock in place, the cartridge is not installed

correctly. Release it and try again.

6 Close the cartridge door.

Make sure it snaps shut.

If the door does not close

completely, the cartridge

is not installed correctly.

Remove it and try again.

7 Flip the handle to the

back of PictureMate

and all the way down.

3 Load Paper

Your PictureMate comes with photo paper made especially

for it.

Caution: Don’t load or print on plain paper; this may damage

PictureMate.

1 Flip up the photo viewer screen.

2 Open the paper

support.

3 Pull up the paper

support all the way.

4 Open the output tray.

Note: Make sure the paper support is fully

extended and the handle is all the way down.

5 Place your paper against

the right edge, with the

glossy side up.

Load up to 20 sheets

at one time.

6 Slide the edge guide

against the paper.

Note: Keep unused paper in the

original package and store it flat

to prevent curling.

PictureMate

Deluxe Viewer Edition

Power cable PictureMate

Photo Cartridge

PictureMate

Photo Paper

Using PictureMate

Without a Computer

booklet

PictureMate

Software

Turn over

Using PictureMate

With a Computer

booklet

Power adapter

4051812-00 XXX

To release lever

Release lever

WrongRight

*410098700*

Printed in XXXXXX XX.XX-XX XXX

Summary of content (6 pages)

PAGE 1
Start Here 2 Install the Photo Cartridge 6 If the door does not close completely, the cartridge is not installed correctly. Remove it and try again. ® 1 7 Flip the handle to the back of PictureMate and all the way down. Release lever 4051812-00 XXX Set up your PictureMate and print –no computer required! 2 Note: To print from your computer, see Using PictureMate With a Computer and your CD after completing these steps. 1 Open the cartridge door on the back of PictureMate.
PAGE 2
Start Here 2 Install the Photo Cartridge 6 If the door does not close completely, the cartridge is not installed correctly. Remove it and try again. ® 1 7 Flip the handle to the back of PictureMate and all the way down. Release lever 4051812-00 XXX Set up your PictureMate and print –no computer required! 2 Note: To print from your computer, see Using PictureMate With a Computer and your CD after completing these steps. 1 Open the cartridge door on the back of PictureMate.
PAGE 3
Start Here 2 Install the Photo Cartridge 6 If the door does not close completely, the cartridge is not installed correctly. Remove it and try again. ® 1 7 Flip the handle to the back of PictureMate and all the way down. Release lever 4051812-00 XXX Set up your PictureMate and print –no computer required! 2 Note: To print from your computer, see Using PictureMate With a Computer and your CD after completing these steps. 1 Open the cartridge door on the back of PictureMate.
PAGE 4
Plug In and Turn On PictureMate 1 Connect the power cable to the power adapter. 2 Plug the small cable into the back of PictureMate. 3 Plug the other end of the power cable into a standard power outlet. 4 Press the On button to turn on PictureMate. On button PictureMate gets the cartridge ready for printing. After a few minutes, you see a message that PictureMate is ready.
PAGE 5
4 Plug In and Turn On PictureMate 1 Connect the power cable to the power adapter. 2 Plug the small cable into the back of PictureMate. 3 Plug the other end of the power cable into a standard power outlet. 4 Press the On button to turn on PictureMate. On button PictureMate gets the cartridge ready for printing. After a few minutes, you see a message that PictureMate is ready.
PAGE 6
4 Plug In and Turn On PictureMate 1 Connect the power cable to the power adapter. 2 Plug the small cable into the back of PictureMate. 3 Plug the other end of the power cable into a standard power outlet. 4 Press the On button to turn on PictureMate. On button PictureMate gets the cartridge ready for printing. After a few minutes, you see a message that PictureMate is ready.