Quick Start Manual

Start Here
3 Slide the edge guide to your paper size.
Letter-size
4 Load paper against the edge guide with the glossy or
printable side facedown.
Note: Make sure the paper is loaded against the edge guide
and not sticking out from the end of the cassette.
5 Slide the edge guides against the edges of the paper,
but not too tightly.
6 Keep the cassette flat as you insert it.
Note: The paper may slide forward slightly as you insert the
cassette. This is normal.
7 Extend the output tray and flip up the paper stopper.
Note: Do not flip up the paper stopper if you’re using
legal-size paper.
Read these instructions before using your product.
1
Unpack
French control
panel stickers
Caution: Do not open ink cartridge packages until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
Remove all protective materials.
2
Turn on and adjust
1 Connect the power cord to the back of the printer and to an
electrical outlet.
Caution: Do not connect to your computer yet.
2 Press the On button, then raise the control panel.
Note: If you want to lower the control panel, squeeze the release
bar underneath and push the control panel down.
Caution: To avoid damaging your product, always squeeze the
release bar to lower the control panel.
3
Select language
Press or to select your language, then press OK.
4
Install ink cartridges
1 Lift up the scanner unit.
2 Open the cartridge cover.
3 Shake the ink cartridges gently 4 or 5 times, then
unpack them.
4 Remove only the yellow tape from each cartridge.
Caution: Don’t remove any other seals or the cartridges may leak.
5 Insert the cartridges in the holder for each color.
6 Press each cartridge down until it clicks.
7 Close the cartridge cover. Press down until it clicks. Then
lower the scanner unit and press OK.
8 Wait while the ink delivery system primes. Priming takes
about 5 minutes.
Note: Your printer ships with full cartridges and part of the ink from
the first cartridges is used for priming the printer.
Caution: Don’t turn off the printer while it is priming or you’ll
waste ink.
9 When you see this menu on your product’s LCD screen, do
not make a selection yet. Continue with the instructions in
the following sections to load paper in your product and
install software.
5
Load paper
1 Pull out the paper cassette at the bottom of the printer.
2 Slide the edge guides to the sides of the cassette.
*412184600*
*412184600*
Epson Stylus
®
NX530