Quick Start Manual

ManualsBrandsEpson ManualsPrintersEpson Epson Stylus Photo 925

Load Paper

1 Load some paper against the right side

of the sheet feeder.

2 Slide the left edge guide against the paper.

3 Pull out the output tray extensions.

Note: For instructions on loading and printing

on roll paper, see your Printer Basics book.

Unpack

1 Insert the paper support into the slots in the back

of the printer.

2 Insert the tabs on the roll paper holders

into the slots at the back of the printer.

Turn over

1 Remove everything from the box.

2 Remove all the tape and packing

material from the printer.

3 Open the output tray and lift the

printer cover. Then remove the

tape and insert.

Attach the

Paper holders

Attach the

Paper Holders

Turn On the Printer

1 Open the output tray.

2 Lift the printer cover.

3 Unwrap the ink cartridges and pull off

the yellow tape seals.

4 Lift up both ink cartridge clamps.

5 Tilt each cartridge toward you

as you lower it into the holder.

Make sure the tabs rest on the

hooks in the back.

6 Lower the clamps so they snap shut.

7 Press the Maintenance button and close the printer cover.

A progress bar is displayed in the

LCD panel during ink charging. It

takes about 2 minutes.

8 After ink charging is finished, press the custom button 1.

Caution: Install both ink cartridges,

and leave them installed for all types

of printing, or the printer won’t work.

You need a USB cable (not included) to connect your printer to your computer.

1 Shut down your computer. In Windows,

click Start and select your Shut Down

or Tur n O ff option.

Leave your computer turned off until section 7.

2 Plug the square end of the cable into your printer’s USB port.

3 Plug the flat end of the USB cable into any available USB port on your computer.

1 Plug the printer’s power cord into

a grounded electrical outlet.

2 Press the silver power button

to turn on the printer.

Connect the Printer

Caution: Never use an external

switch, such as a wall switch or

power strip switch, to turn the

printer on or off.

Caution: Don’t turn off the printer

or interrupt charging while the light

is flashing or you’ll waste ink.

Install the

Ink Cartridges

Install the

Ink Cartridges

Paper support

Ink cartridges

Roll paper holders

Printer

Printer Basics Quick Reference

Printer cover

Output tray

Note: For instructions on

using the roll paper holders,

see your Printer Basics book.

EPSON Stylus Photo 925

EPSON Stylus

Photo 925

CPD-14609

Printer Software

CD-ROM

Start

Here

Start

Here

Roll paper sample

Summary of content (2 pages)

PAGE 1
EPSON Stylus Photo 925 2 Attach the Paper Holders 5 Install the Ink Cartridges 1 1 Paper holders EPSON Stylus Photo 925 ® Start Here Insert the paper support into the slots in the back of the printer. Ink Cartridges Open the output tray. Printer cover 2 Lift the printer cover. Output tray 2 Insert the tabs on the roll paper holders into the slots at the back of the printer. 3 Note: For instructions on using the roll paper holders, see your Printer Basics book.
PAGE 2
7 Install Software Windows 98 (continued) Macintosh OS 8.5.1 to 9.x 5 If you’re using Macintosh® OS X, see “Installing Your Printer Software” in the Printer Basics book for instructions. Click the Search for option, then click Next. Windows The installation works differently depending on the version of the Windows you’re using. 1 Make sure your printer is connected and turned on. Then turn on your Macintosh. If you see this screen, click Cancel. 2 Put the EPSON CD-ROM in your CD-ROM or DVD drive.