Owner's Manual

Copying Without a Computer 29
Saving and Reusing Copy Settings
You can save one set of custom copy settings so you can quickly reuse it for a
similar copying job (for example, 5 × 7-inch photos on Premium Glossy Photo
paper). You can then “reprint” photos by pressing a single button.
1. After selecting settings, press and hold the
Recall button until you see
The current setting has been saved on the LCD screen. Then press OK.
If you want to save a different group of settings, repeat step 1. This replaces
your previously saved settings.
2. To use your saved settings, press the
Recall button until you see Recalled on
the RX600 screen. Then press
OK.
Canceling Copies
To cancel a job in progress, press the y Stop button. Canceling appears on the
RX600 screen and your page is ejected.
Restoring Default Settings
If you want to reset copy and print settings to their original default settings, follow
these steps:
1. Press the
Setup button.
2. Use the u and d buttons to choose
Restore to Factory Settings.
3. Press
OK, then press OK again to restore your settings.
4. You see a confirmation message that settings have been restored. Press
OK.
sprx600usersguide.book Page 29 Wednesday, February 25, 2004 1:47 PM